RV-D10 Wraparound forming machine (bottom type)
Features
Uses vertical transport and forming.
Uses a blower head for product suction, and twin-axle servo motor for the transfer section.
Product feed and sheet feed can be from either the left side or the right side, enabling easy layout.
Safety covers extend over the entire machine, operated by cover switches.
Can be connected to a sheet feeding device for prolonged continuous operation.
Problems can be easily identified and corrected from the machine's touch panel.
Operation Flow
This machine receives product units from upstream, arranges these units into groups of 4 (or 6 or 8) x 5, and loads each group into a corrugated sheet that is already waiting in position within. The loaded sheet then drops down, the front and rear flaps are folded, and then the top flap is folded. With the loaded sheet in motion, the inner flaps on both sides are folded, and then the outside bottom flaps are folded and hot-melt is applied to them. The outside upper flaps are folded, completing the box formation. Pressure is then applied to both sides, and the finished box is ejected from the machine. A downstream turning device rotates the box 180 degrees, and the box is conveyed out of the system.
Specifications
Video
